Featured
How Is A Gauge Line Tightened On A Fitting
How Is A Gauge Line Tightened On A Fitting. After you mount the gauge, set the compensating valve from close to open. This is your reference mark.

Fitting until the front ferrule seats against the fitting body; Intersection between the one horizontal line and two vertical lines will give you the two centre points of the holes. Step # 5 purging air from hoses and combining pressures loosen the hose connection on the.
1.2 Holding Tools 1.2.1 Bench Vice The Bench Vice Is A Work Holding Device.
Step # 4 releasing high side pressure crack the liquid line service valve off the backseat replace the service valve cap on the liquid line service valve open the high side valve on the gauge manifold open the low side valve on the gauge manifold. Intersection between the one horizontal line and two vertical lines will give you the two centre points of the holes. Then tighten nut with spanner the appropriate amount as indicated on the diagram to the left.
This Gap Is Measured By Means Of A Feeler Gauge, Consisting Of Small Bits Of Steel Plates Of Varying Thickness, Which Can Be Inserted Into The Gap.
Piece of braided line to the isolator on the gauge side. Attach a suitable section of vacuum line to the fitting on the tank. The gm mechanical oil pressure gauges utilize a special type of compressionfitting to connect the 1/8 od tubing to the port on the back of the gauge.
Pull A Vacuum With The Syringe, And Lock The Plunger In Place With A Pair Of Vice Grips.
By doing this in iterations, you minimize the risk of over tightening. Once the fittings are attached to the isolator connect the 3ft. Bottoms in the fitting body.
The Assembly Process Divides In 3 Steps.
After you mount the gauge, set the compensating valve from close to open. Mark a line along the nut and fitting body flats. It occurred to me that lapping the flare on the brake line could get the tube to seat with the fitting.
You Can Always Tighten It More If You Under Tightened It, But Once You Over Tighten, You Have To Get A New Ferrule.
Test for leaks, and if found, add another quarter to half a turn until the leak stops. Ways be placed in the back seated position before installing or removing gauges. Use the swagelok mhsu gap inspection gauge to ensure that the fitting has been tightened sufficiently.
Comments
Post a Comment